How to refit the handle of a Charlbury rinse

Isolate water supply before starting

Unscrew and remove the spray cover and rubber seal

Remove inner brass ring

Take care to keep upright to ensure inner fittings do not fall out

Using the end of a wooden spoon or similar, push the inner mechanism towards the lever

The pin and lever can be removed to reveal the internal shaft

Whilst holding in position, line up the lever and place the pin through both holes

Release the internal mechanism to return back to original position

Re-fit all other parts in reverse order. NOTE: do not over tighten the spray cover – doing this will take pressure off the pin and cause it to fall out